$2.00 – $143.00
CLEAR NATURAL OIL-BASED UV PROTECTIVE FINISH
- Clear Natural Oil-based finish with 12x UV-Protection
- Very water and dirt resistant
- Reduces wood swelling and shrinkage
- 410 Clear is safe for humans, plants and animals once dry
- 420, 425, 428 & 429 contains biocides to prevent the growth of algae, mildew and fungal attack
- Microporous, breathable finish which does not crack, peel, flake or blister
- No sanding necessary for future applications
+5°C to 35°C
16m²/L (172ft2/L) with one coat
|Approx. Dry Time||
|Number of Coats||
410 Clear, 420 Clear Extra, 425 Oak Extra, 428 Cedar Extra, 429 Natural Extra
2.5L, 750mL, Sample Sachet (5mL)
Ensure that wood surfaces to be treated with Osmo UV Protection Oil are clean, dry and frost-free (moisture content max. 20%).
- Surfaces should be sanded with a 120 grit abrasive and no finer
- New wood and especially hardwoods should be allowed to weather for approximately 6 weeks prior to oiling
- De-grease surfaces with methylated spirit or Osmo Brush Cleaner and Thinner (8000) before oiling
- Fill any holes or gaps with an exterior gap sealer
Please Note: Allowing the wood to weather, especially dense exotic hardwoods, enables the tight, dense grain of the timber to open up. This makes it easier to apply the oil and allows it to penetrate deeper in to the wood grain.
- Clean old microporous finishes (wood oils) thoroughly
- Areas affected by mould, algae and moss must be cleaned and treated
- Old paints, lacquers and varnish like stains must be completely removed
- The colour of timber that has turned grey / silver over time can be restored prior to oiling with Osmo Wood Reviver Gel (6609)
- Then treat as New Wood
Always do a test area before starting any project to check suitability and compatibility. Follow the manufacturer’s instructions on the tin at all times.
- Stir thoroughly before and periodically during application
- Where possible treat all sides of the timber prior to installation
- Apply protection oil thinly along the wood grain with a natural bristle brush
- Work the oil into the surface of the wood grain
- Wipe of any excess with a clean, lint-free cloth
- Allow to fully dry
- Apply a second coat as above
Oiled surfaces can be regularly cleaned with a suitable exterior spray cleaner that won’t strip away the waxes and oils.
When renovation is required, ensure that surfaces are clean and dry.
- Lightly sand or use a stiff brush to remove surface dirt and debris
- Apply a thin maintenance coat of Osmo UV Protection Oil, taking care to work the oil in to the surface of the wood and wiping off any excess
- For wood that has become discoloured or is showing signs of mould, algae or moss, refer to the preparation and application sections above